The mobiles come out of the 3D-printer completely assembled as shown in the photos and video. The balance points for these mobiles were calculated to 1/1000th of a millimeter (1/25360th of an inch). The models for some of the mobiles were drawn up "by hand", others were created utilizing scripts that they wrote. Some of the mobiles, like Mobile 4.2, are designed with a very small increase or decrease in thickness from one part to the next, something that is not possible to do with conventional handmade mobiles. Utilizing scripts also allows for designs that would be very time consuming to make by hand, such as the Quaternary Tree (Level 6), which has 1365 pieces.
Marco Mahler and Henry Segerman met via Twitter in early February 2013 when Henry Segerman was looking for suggestions for a motor for one of his 3D printed kinetic sculptures. A conversation ensued about the possibilities for making 3D printed mobiles. After about 300 emails, several conversations over Skype, hundreds of lines of code, a number of test prints and trial-and-error experiments, the result is this collection of mobiles.
All models are available in a white laser sintered nylon plastic, one of the most popular materials for 3d-printing. Some of the smaller models are also available in black and a variety of other colors. The retail prices for these mobiles start at US$10 (Mobile 1) and go to US$600 (Quaternary Tree Level 6). They're available at www.shapeways.com/shops/mobiles.
Info, photos (including hi-res photos) and video at
4110 SE Hawthorne Blvd #310
Portland, OR 97214
Ph: (USA+) 503.724.5545
SOURCE Marco Mahler