About time Cadence woke up... working with large FPGAs is tough enough, but when you try to keep the PCB in-sync with the front-end, it is a long and tedious problem. I tried Mentor and had to buy I/O Designer, which worked, but still felt like a manual process. Someone told me that Altium has this as an integral part of their product and works automatically. I just completed an evaluation and I find it works perfectly. I can pinswap my Virtex II to make routing cleaner and then "magically" see the changes in the schematic. BRILLIANT!!!
So look at this new tool from 7Circuits + OrCAD + Allegro, then look at DxDesigner + I/O Designer + PADS or Expedition, then look at Altium Designer 6 - Board.
I am sure you will choose Altium. Just my two cents.
|
Selain menerima orderan dari perorangan, Asiacon turut menerima pemesanan beton pracetak juga layanan pemasangan paving block dari perusahaan-perusahaan di Indonesia. Jumlah proyek yang mereka tangani cukup banyak bahkan meliputi area pergudangan, pelabuhan dan lainnya. Layanan yang Ditawarkan Asiacon.
Sayangnya tidak banyak yang mengetahui jika Buis beton Asiacon tidak hanya memproduksi beton pracetak saja tapi turut menawarkan beberapa layanan.
|
EMA Adds FPGA I/O Synthesis Tool to Its PCB Offerings
